DL1 DS Link Nikon TTL Converter Ikelite
NT2 Hotshoe Kit
Product # 46054
Included in the Box
•
DL1 DS Link Nikon TTL Converter
•
Plug o-ring # 0136.13 (installed)
•
Connector protector # 0301.12 (installed)
•
Waterproof bulkhead cap # 9104.7 (installed)
•
NT2 Nikon TTL Hotshoe # 46064
•
Silicone lubricant 1cc tube
Strobe Compatibility
•
Ikelite DS50 above serial # 75510
•
Ikelite DS51 above serial # 78700
•
Ikelite DS125 above serial # 7928
•
Ikelite DS160, DS161
•
Ikelite DS200 above serial # 7163
»
The DL1 DS Link is not compatible with other
manufacturers’ strobes.
Sync Cord Compatibility
•
Ikelite Housing to Ikelite Strobes # 4103.51
•
Ikelite Housing to Two Ikelite Strobes # 4103.52
•
Ikelite Housing to Ikelite Strobes # 45051
•
Ikelite Housing to Two Ikelite Strobes # 45052
»
Use of two strobes requires a dual sync cord. Two
strobes cannot be controlled by individual converters
even if the housing is equipped with two bulkheads.
Camera Compatibility
Compatibility may be updated as new cameras are released.
Refer to the product page on our website for up to date
camera compatibility information.
Installation and Use
Installing the NT2 TTL Hotshoe
1.
Depress the tab on the manual hotshoe connector and
gently pull connector ends apart to remove the housing’s
manual hotshoe.
2.
Align TTL hotshoe and bulkhead connector ends and
push together until tab clicks into place.
3.
Push hotshoe forward into camera’s hotshoe mount.
Make sure that the hotshoe is all the way forward to
ensure proper connection.
»
The NT2 TTL Hotshoe is only intended for use with
compatible Ikelite brand housings.
Attaching the Converter
1.
Remove connector protectors and bulkhead caps from
each connection.
2.
Apply a very thin, even layer of lubricant on all threads,
sealing surfaces, and the exposed portion of the plug
o-ring. Do not allow lubricant to get into the pins and
receptacles of the plug or bulkheads.
DL1 DS LINK
MADE
IN USA
Retaining ring
Mode button
LED indicator
Bulkhead
Plug o-ring