Drill an opening for the fixation stick of the fuselage with a 3
mm borer. Attach this at a 90 degree angle by using glue.
Depending on what kind of battery is intended to be used, cut
an opening for the cable-binder that is thought to affix the
battery.
Inserting the engine
Slide the engine-socle onto the fuselage stick that was
roughened and glue it with CA-glue. The axis of the engine
should be in a 2° angle downwards which is predetermined
by using the Ikarus Engine Set (No. 160611). Please
connect the Engine Micro Speed Controler 2000.
Cut the body and the cabin cover with scissors and a knife
along the marked lines. Smooth the edges afterwards for
using fine sandpaper. Please leave some room for this
when cutting along the lines.
230mm from the stern, make a 5 mm boring. Insert the
rubber cover here, fix the fuselage here. Glue the side
rudder on the fuselage as marked on the body of the plane.
At the end glue the cabin cover and decorate the model
according to the picture on the cardboard. The rivets and tin
decoration are made by using an inkpen.
m
230
m
Rubber cover
2°
Mark the centre of gravity and hold the model at this point
on a fingertip. It should be horizontal now. If this is not the
case, use the batteries to balance until the correct horizontal
position is achieved.
3
175mm
