UNO Synth
Pro Editor
5 - The Synth Panel: EFFECTS
18
Chapter 5 – The Synth Panel: EFFECTS
The UNO Synth PRO has 4 effects blocks with settings that are saved per preset.
Controls:
• Drive knob: This sets the amount of post filter overdrive.
• Modulation section: Here you can choose the type of modulation effect between Chorus, Phaser and
Flanger. For the Chorus, there are 3 different modules to further choose from: Synth 1, Synth 2 and Strings.
There are knobs for Intensity and Rate as well as a large knob for the Amount (volume) of the Modulation
Effect.
• Delay section: Here you can choose between 5 digital delay algorithms: Mono, Stereo, Doubler, Ping Pong
and LCR. Depending on the model chosen, the knobs below will represent the available parameters. For
the Mono Delay algorithm, there are controls for Time, Feedback and the low-pass filter cutoff frequency.
There is a Sync button that will synchronize the delays to the master tempo. When Sync is on, the Time
parameter will be displayed as a musical note value. At the bottom of the Delay section, there is also a large
knob for the Amount (volume) of the Delay Effect.
• Reverb section: Here you can choose between 4 reverb types: Hall, Plate, Reverse and Spring. Depending
on the reverb type selected, the knobs below will represent the available parameters. For the Hall type,
there are knobs to set the Pre-Delay, Size, Time, Filter, Low Time and High Time. At the bottom of the
Reverb section, there is also a large knob for the Amount (volume) of the Reverb Effect.
