Draco MultiView 4K
60
Operation via Keyboard
147
10.2 Focusing on one Input via Keyboard Command
Depending on the current display mode, the window arrangement remains or changes when focusing on
another input. The USB-HID control is switched to the selected input. The focusing results are described in
the respective sections.
To focus on another input, the following keyboard commands are available:
Keyboard command
Function
Hot Key, 1, Enter
Focus on input 1.
Hot Key, 2, Enter
Focus on input 2.
Hot Key, 3, Enter
Focus on input 3.
Hot Key, 4, Enter
Focus on input 4.
Example for Focusing on one Input in Fullscreen Mode
•
The video signal of the selected input is streamed in the window on the main monitor.
•
Monitor 2 shows a mirrored image of the main monitor.
•
The USB-HID control is switched to the selected input.
•
Both audio outputs output the audio signal of the input with USB-HID control.
To focus on another input, proceed as follows:
1. Press the
Hot Key
to start the command mode (see chapter 4.1, page 48).
2. Press the number of the specific input (e.g.,
4
) to be switched and press
Enter
.
The video signal of the selected input
4
is displayed on the main monitor and mirrored on monitor 2.
The USB-HID control is connected to the associated source. The command mode is closed, and the
keyboard LEDs returned to their previous status.
Fig. 117
Fullscreen Mode - Focusing from two to one input
When using the numeric keypad for switching in Fullscreen Mode, a confirmation of the switching operation
by pressing Enter is not necessary.
