Draco tera enterprise
Safety Instructions
15
2
Safety Instructions
To ensure reliable and safe long-term operation of your device, please note the following guidelines:
Read this user manual carefully.
Only use the device according to this user manual. Failure to follow the instructions described can
damage the device or endanger the security of your data.
Take any required ESD precautions.
WARNING
Risk of electric shock due to freely accessible power connections when the chassis is open
Risk of bruising, abrasion or shearing of fingertips due to rotating fan when the chassis is open
If the chassis is opened while power is supplied to the device, electric shock may occur if the internal
wiring is touched. If a running fan is touched while the case is open, bruises, abrasions or shearing of
fingertips may occur.
There are no necessary maintenance procedures that require opening the chassis.
Do NOT remove the cover of the chassis.
Do NOT install the device in environments where children are likely to be present.
CAUTION
Risk of burns due to tremendously heated chassis surface after a long period of operation
The surface of the chassis can become very warm after a long period of operation. If the chassis surface
is touched after a long period of operation, this can cause skin burns.
Protective gloves must be worn to transport a fully equipped chassis after a long period of operation.
Ensure that there is sufficient distance from the operator.
Do NOT install the device in environments where children are likely to be present.
Installation location
While operating, the device and the power supply units can get warm. Damage to the device can occur in a
damp environment.
Use the device only in dry, indoor environments.
Use the device only in a room with adequate ventilation.
Existing ventilation openings on the device must always be free (lateral and rear).
Do not place the power supply units directly on top of the device.
For rack-mount installations, at least 0.5 RU (rack unit) is required above the device for ventilation.
Place all power sockets including the sockets for the supplied external power supply units easily
accessible and directly next to each other.
