Configuration via OSD
Draco Multiview 4K60
50
5.6 Saving and Loading Configuration
NOTICE
By default, the last configuration that has been saved in the permanent Draco MV memory will
be restored after a restart of the Draco MV.
First starting the Draco MV, the factory configuration will be copied in the current configuration.
You have 2 possibilities to save save configuration changes:
saving the current configuration permanently in the Draco MV memory or
saving the configuration in up to 8 predefined storage locations, as well as the default
configuration in the memory of the Draco MV
5.6.1 Saving Active Configuration
NOTICE
Changing or saving configurations blocks the Draco MV memory and leads to a freeze of all
OSD menus for a few seconds. The switching connections are not affected by this freeze.
To save the current configuration permanently in the Draco MV storage, proceed as follows:
Select
Configuration > Save
in the main menu.
The current configuration of the Draco MV is permanently saved to the Draco MV memory.
Fig. 36 Menu
Configuration - Save