Configuration via Management Software
SNMP Module
38
5.4.2 Setting the Network Configuration
The parameters for the network configuration are set in this menu.
NOTICE
A change in system-relevant parameters (e.g. change of the IP address) is immediately displayed in the
management software. To initialize system-relevant configuration changes on the SNMP module, the
SNMP module must be restarted. The restart of the SNMP module may take several minutes, and the
SNMP module is not available during the restart.
Fig. 27
Management software menu
System Settings - Network - General
The following parameters can be configured:
Network Settings
Field
Entry
Description
DHCP
Activated
The network settings are automatically supplied by a DNS
server.
Note:
If DHCP is activated and there is no physical network
connection available, the boot times might increase.
Deactivated
Function not active (default)
IP Address
Byte
Input of the IP address, if DHCP is not active (default:
192.168.100.99)
Subnet Mask
Byte
Input of the subnet mask in the form “255.255.255.0”, if DHCP is
not active (default: 255.255.255.0)
Gateway
Byte
Input of the subnet mask in the form “192.168.1.1”, if DHCP is
not active
MAC Address
Byte
Cannot be changed, is called up automatically