P/N 900418-00
Rev. NC 01/2015
HEARTH PRODUCTS
SUPPLEMENTAL INSTRUCTIONS
NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.
FRONT AND END FACE ASSEMBLY
REMOVAL AND REINSTALLATION
DIRECT VENT AND B-VENT GAS FIREPLACES
DANGER
HOT GLASS WILL CAUSE BURNS.
DO NOT TOUCH GLASS UNTIL COOLED.
NEVER ALLOW CHILDREN TO TOUCH GLASS.
• Install only when fireplace is OFF and COLD.
• Fireplace surfaces get EXTREMELY HOT!
• The glass on the front of the fireplace reaches EXTREMELY HIGH
temperatures and can cause severe burns if touched. Even after
the gas is turned off, fireplace surfaces remain extremely hot.
NOTE: The barrier contained herein is designed to reduce the risk
of burns from the hot viewing glass and shall be installed for the
protection of children and other at-risk individuals.
FRONT AND END FACE ASSEMBLY WITH BARRIER
REMOVAL AND REINSTALLATION INSTRUCTIONS
P900418-00
All barriers are designed to reduce the risk of injury from contact with
hot glass. See warnings in the Installation and Care and Operations
manual (IICO) for fireplaces which require a barrier.
REMOVING THE FRONT FACE OR END ASSEMBLY FOR CLEANING OR
OTHER MAINTENANCE
Do not remove rthe front face or end assembly unless the fireplace is
off and the appliance is cool. All front face and
end
assemblies with
barriers must be in place when the fireplace is in use.
In fireplaces with front face or end assemblies (see Figure 1), remove
the assembly in the following manner:
Remove the front face or end assembly by lifting top and bottom
evenly approximately 1/2” and pulling straight out from the unit once
the brackets are disengaged.
NOTE: Front face or end assembly with barrier must be reinstalled
prior to operation.
NOTE: If the barrier becomes damaged, the barrier
must be replaced with the manufacturer’s barrier
for the appliance.
See
barrier identification label
on barrier.
Assembly
Barrier in
Assembly
Assembly
Brackets
Figure 1 - Typical Assembly with Barrier
Reinstall the front face or end assembly in the following manner.
1. Hold the assembly with its brackets approximately 1/2” from and
1/2” above the slots in the face of the fireplace
2. Move the assembly into place with assembly brackets directly above
the fireplace slots by pressing the assembly against the unit
3. Push the assembly down over the slots, engaging them and holding
the assembly in place
f i r e - p a r t s . c o m
