IHP 900935-00 Placement Manual Download Page 1

1

GAS LOG SETS

P/N 900935-00

Rev. NC, 10/2018

HEARTH PRODUCTS

KITS AND ACCESSORIES

KIT CONTENTS

1 ea. Log Set

1 ea. Instruction Sheet

GAS LOG PLACEMENT GUIDE FOR INSTALLING GAS LOG SETS

[For Use With Aries35, DRT2035, Bellevue 32, and DRI2032 Series Direct-Vent Gas Fireplaces/Inserts]

GENERAL INFORMATION

This log placement guide has been prepared to present detailed log placement 

illustrations and provide instruction to assist in the setup of replacement 

logs and after the annual cleaning and inspection cycles. The information 

provided here is to be used in conjunction with the Installation and Operation 

Instructions provided with the appliance. 
If you encounter any problems, need clarification of these instructions or are 

not qualified to properly install this kit, contact your local distributor or dealer.
Read this instruction sheet in its entirety before beginning the installation.
DO NOT attempt to install the logs until the appliance installation has been 

completed, the gas line connected and tested for leaks and the initial burner 

operation has been checked out.
The logs have notches/tabs/pins to assist proper positioning. Proper log 

placement is critical to prevent sooting. Place the logs in the gaps between 

flame peaks, so they do not impinge the flames. Follow the log placement 

instructions precisely.
ALL WARNINGS AND PRECAUTIONS IN THE INSTALLATION AND OPERA-

TION MANUAL PROVIDED WITH THE APPLIANCE APPLY TO THESE 

INSTRUCTIONS.
SHUT DOWN THE APPLIANCE AND ALLOW IT TO COMPLETELY COOL 

BEFORE PROCEEDING.

Log Set

I.D.#

Description

1

Left Rear Log

2

Left Front Bottom Log

3

Right Front Bottom Log

4

Right Rear Log

5

Twig Log

1

4

2

3

5

1

4

2

3

5

TOOLS NEEDED

None

INSTALLATION INSTRUCTIONS
Pre-installation Instructions:

1.  Allow the fireplace to cool completely before proceeding.

2.  Remove the barrier and door (see instructions in the Installation and 

Operation Manual provided with the appliance). 

3.  Remove the old logs that need replacing. Discard old logs.

Install new logs per the following instructions:

1.  Locate the placement tabs (Figure 2).

2.  Bend up the log placement tabs (Figure 2)

3.  Install the rear left log (1) (Figure 3).

Figure 2 - Locate the log placement tabs

Figure 1 - Log Set

Tabs for

Log #1

Tabs for

Log #2

Tabs for

Log #4

Tabs for

Log #3

Figure 3 - Place left rear log (1)

Front View

Bottom View

1

Slots fit over Tabs shown in Figure 2

f i r e - p a r t s . c o m

Summary of Contents for 900935-00

Page 1: ... pins to assist proper positioning Proper log placement is critical to prevent sooting Place the logs in the gaps between flame peaks so they do not impinge the flames Follow the log placement instructions precisely ALL WARNINGS AND PRECAUTIONS IN THE INSTALLATION AND OPERA TION MANUAL PROVIDED WITH THE APPLIANCE APPLY TO THESE INSTRUCTIONS SHUT DOWN THE APPLIANCE AND ALLOW IT TO COMPLETELY COOL B...

Page 2: ...ttom log 3 Top View Bottom View 3 Slots fit over Tabs shown in Figure 2 6 Install right rear log 4 Figure 6 This log should be placed as far to the right as the slot allows 7 Install the twig log 5 Figure 7 This log rests on the left rear log and the grate Figure 6 Place right rear log 4 4 Slot fit over Tab shown in Figure 2 Top View Bottom View Figure 7 Place twig log 5 Bottom View Top View 5 For...

Page 3: ...is even and equal 1 2 INSPECT GASKET AND ADJUST IF NECESSARY see pictures above 1 Ensure the gasket is properly positioned and area to keep clear is as shown 2 Inspect gasket after installation to ensure it appears as shown above Inside view of glass door showing proper gasket positioning With door installed ensure gasket is posi tioned as shown Gasket Gasket SEE WARNING BELOW WARNING Reinstall an...

Page 4: ...rth Products IHP reserves the right to make changes at any time without notice in design materials specifications prices and also to discontinue colors styles and products Consult your local distributor for fireplace code information 1769 East Lawrence Street Russellville AL 35654 fire parts com ...

Reviews: