8
9
Advanced settings
Settings in this menu are locked as they effect the performance,
function, and safety of the eBike and are intended to only be monitored
or reset by authorized iGO service representatives. Should you believe
settings in this menu require attention contact iGO support.
Reset
Select ‘yes’ to reset the eBike’s bluetooth connections.
Any previous link to an iGO Ride mobile app account will be abandoned and
the eBike will become detectable by other iGO Ride mobile app users.
CAUTION.
If the ‘reset’ icon shows a hand icon (see left) your display
requires updating to a more recent firmware version.
Selecting ‘yes’ in the reset setting when running outdated firmware
will fully reset the eBike to factory settings and may require
reprogramming in order to re-enable certain functions.
If you see the hand icon update the firmware immediately through
the iGO Ride mobile app before proceeding to use your eBike.
(see page 27 for instructions how to check and
install updates using the iGO Ride mobile app)
iGO DRIVE
Advanced information menus
Short press the MODE button to toggle through advanced information display on the screen :
Settings menus
Press and hold MODE button within 10 seconds of turning on
display to access the parameter settings menus.
PARAMETER SETTINGS
Use the UP and Down arrows to move between options. Short press the
MODE button to select or long press the MODE button to go back.
Note:
The menu will automatically quit after 30 second of inactivity.
The menu will automatically quit when you start riding.
For safety reasons you cannot change settings while riding.
Basic settings
Unit : set to km/h or MPH
Set time : Adjust displayed time (clock)
Maintenance : set distance traveled until the service reminder is shown
Backlight : set screen brightness
Autosleep : set period of inactivity until screen turns off
Password : enable* (then enter a 4 digit code) or disable
*when enabled, the selected 4 digit code will be required every time the display unit is
powered on, before the eBike electrical system can become operational. A password prompt
will show at start up. The correct code must be entered to access the electrical system
controls and cyclocomputer interface.
PLEASE TAKE CARE TO REMEMBER YOUR PASSWORD AND ENSURE THE PASSWORD IS KEPT SAFE
Information
Providing detailed information for the display, battery and controller.
The installed firmware version (for display, battery and
controller) can be viewed within this menu.
FOR DISPLAY FIRMWARE VERSION : A.27.23.1
• Trip time
• Average speed
• Max. speed
• Odometer
• Battery voltage
• Battery capacity
• Total charge cycles
• Remaining range estimate
• Average motor power (Watts)
• Max. motor power (Watts)
• Rider exercise (Calories)
• Rider vs Motor (%)
Comparative analysis showing
percentage use of assist
power segments.
TOUR
[ ECO ]
[ TOUR ]
[ SPORT ]
[ TURBO ]
[ BOOST ]
