54
55
SERVICING
Servicing your bike is very important. You can avoid unnecessary
damage by servicing your bike regularly.
General maintenance
• Check tire pressure regularly
• Check brake wear every month and adjust
• Clean and Lubricate the chain occasionally
• If caught in the rain ensure bike and electrical components are
wiped dry, remove battery and allow to dry over night
• It is recommended to have your bike evaluated every 3
months by a professional bicycle technician
Before every ride
• Make sure battery is charged and locked into position
• Check tire pressure
• Check brakes for proper braking
• Always wear an approved bicycle helmet
CLEANING
Regular cleaning of your electric bike will prolong its life and
reduce the appearance of rust and corrosion build up.
REMOVE THE BATTERY BEFORE CLEANING and use brushes and wet
sponges to remove dirt. Finish by drying with paper cloths / towel.
(Use of a mild soap solution, degreaser, chain lube and a chain
cleaning device are recommended for a thorough cleaning.)
When cleaning the electric bike do not submerge parts or let water accumulate by the
battery or electrics as prolonged exposure to water may damage these components.
Note:
Do not use a hose or pressure washer to directly spray the bike. This may
result in irreparable water damage and will void your warranty.
PART
SCREWS / BOLTS
TORQUE VALUE
Rear derailleur
mount bolt
cable screw
8 - 10 Nm
5 - 7 Nm
Gear lever
mount bolt
5 Nm
Cassette
lockring
40 Nm
Crank
mount bolt
45 - 50 Nm
Pedal
pedal axle
25 - 35 Nm
Saddle
seat post with 1 fitting block
seat post with 2 fitting blocks
22 Nm
12 Nm
Seat post
clamp
5 - 7 Nm
Stem
faceplate
steerer
5 Nm
6 - 8 Nm
Grips
clamp screw
2 - 3 Nm
Rack
mount screw to the frame
5 Nm
Fender
mount bolt on the fork
mount bolt on the rack/frame
5 Nm
5 Nm
Kickstand
bolt
6 - 8 Nm
Brake lever
handlebar mount screw
4 - 5 Nm
Disc brake
rotor screw
4 Nm
Brake caliper
mount bolt
5 - 7 Nm
TORQUE TABLE
The following table provides the recommended torque values for components.
Ensure all fasteners are tightened carefully and checked regularly. Use
of a torque wrench is advised to check values are correct.
Never exceed the recommended torque values.
Some components may have torque values indicated on the part.
Always respect the indicated recommended values.
iGO ASSIST