en
19
User manual Monika 2, Rota
www.igloo.pl
7. THERMOSTAT SERVICE
7.1. „IGLOO” thermostat
Fig.13 „Igloo” thermostat control panel
Veri
fi
cation of adjusted temperature (inside the device) – By pressing “
▲
” or “
▼
” switch once we can verify the adjusted
temperature. The adjusted temperature shall be shown on the display with a visible red blinking spot (diode). The preview
shall
fi
nish automatically after about 3 seconds.
Lowering (or increasing) the temperature – press “
▼
” (or “
▲
”) switch and the adjusted temperature shall be visible on
control panel. By pressing the “
▼
” switch we decrease the temperature to the desired value. The preview shall
fi
nish
automatically after about 3 seconds.
Manual defrosting – switch No. 2 enables to initiate the defrosting cycle at any moment when the device is working (re-
gardless of the automatic defrosting function); the switch shall not operate when the temperature is higher than the
fi
nal
defrosting temperature.
The user should switch on/ switch off the aggregate only by means of the main switch of the device, and
not by means of the direct switch on thermostat control panel. Switching on the main switch shall automa-
tically initiate the thermostat!
* Read more on www.igloo.pl
1 – Cooling on/off switch
2 – Manual defrosting switch
3 – Aggregate and defrosting operating control diode
4 – Temperature monitoring switch on defrosting sensor
5 – Temperature regulation switch (increase)
6 – Temperature regulation switch (decrease)
2
1
3
4
6
5
