![background image](http://html1.mh-extra.com/html/igenix/ig9907/ig9907_user-manual_3926703008.webp)
8
Positioning the Appliance
This unit can easily be moved from one room to another on the rolling castor wheels, please note
that whilst moving the unit, it should be kept in an upright position.
• The exhaust heat must be expelled through a window, door
or vented through a wall; whilst in air cooling or heating
mode. For best results it is recommended to vent through
a wall duct.
• Ensure the unit is positioned on a flat and even surface,
at least 50cm away from wall, curtains, draperies, or heat
sources to ensure adequate air circulation.
• The exhaust hose can be extended from 30cm to 150cm,
but it is recommended to use as short as possible as this
will minimise the escape of any expelled air and offer better
results.
• The exhaust air must flow freely. Avoid kinks and bends in
the hose more than 30 degrees as any blockages can lead to
the unit overheating.
Warning:
Do not use the unit in a wet room, such as a bathroom or laundry room or in areas
where the unit is likely to get splashed.
Important:
The length of the exhaust hose has been designed according to the specification of
the appliance. Do not extend the exhaust hose with any other product as this could lead to the
unit malfunctioning
Using the Window Slider
Fig.5
Fig.6
Vertical
Vertical
Window
Window
Horizontal
Horizontal
Window
Window
Window slider
Window slider
Window slider
Window slider
The window slider kit has been designed to fit most standard vertical and horizontal window
applications, however, it may be necessary for you to modify some aspects of the installation
procedures for certain types of windows. The window slider kit can be fastened with screws.
Cut on opposite
side of hole
Note:
If the window opening is less than the minimum length
of the window slider kit, cut the end without the hold in it short
enough to fit in the window opening. Never cut out the hole in
window slider kit.