![background image](http://html1.mh-extra.com/html/igenix/ig9902/ig9902_user-manual_621563010.webp)
10
DRAINAGE
This air conditioner has a Built in Self-Evaporating System, the water is recycled to cool the condenser
coils and the excess is evaporated. It also has a Built in Water Tank to collect excessive humidity from
air when the humidity of the room is extreme damp e.g. above 90%. The drain pipe is to drain water out
from the tank when it is full. The Self-Evaporating System will not be actioned when the compressor is
not on activated, e.g. when the unit is on heating or fan mode.
During the process of Cooling some water will be extracted from the air into the unit. If the Internal
Water Tank is full, both the compressor and motor will stop and the unit will buzz (any button can be
pressed to stop the buzz), the Full Water Tank indicator (Fig 13 [8]) will flash. To continue using the
cooling function, empty the internal water tank by following the process below.
• Ensure the unit is switched off and unplugged from the
socket, trying not to move.
• Position a container (e.g. water tray) underneath the drain hole.
• Remove the Drain Cap and Rubber Plug from the
Drain Hole and allow the water to drain out.
• When the container is almost full, replace the Rubber
Plug in the Drain Hole and empty the
water tray. Repeat until the Internal Water Tank is empty.
• Once completely empty, replace the Rubber Plug in the
Drain Hole and firmly tighten the Drain Cap.
• The unit can now be plugged back in and switched on, the
Full Water Indicator or Compressor Operating Indicator
should not be flashing (Fig 15)
If you wish to operate the unit without the need to empty the
Internal Water Tank then the Drainage Tube can be used (Fig 3 [14]).
• Remove the Drain Cap and Rubber Plug and retain for future use
(Fig 16).
• Connect the drainage tube to the water outlet hole
and place over a drain.
• The drainage tube may be extended by adding an extension tube
(18mm) and a suitable connector
to secure the two (Fig 17).
Important: The drain must be at or below the outlet level to
allow drainage. The Full Water Indicator will not function when
using the Drainage Tube.
Fig15.
Fig16.
Fig17.
Drain knob
Rubber hole
Rubber plug
Drain knob
Rubber hole
Rubber plug
Originally
supplied
tube
Extension tube
(OD: 18 mm)
Important: This air conditioner has Built in Self-Evaporating System, the water is recycled to cool
the condenser coils and the excess is evaporated. It also has a Built in Water Tank to collect excessive
humidity from air when the humidity of the room is extreme damp e.g. above 90%.” The drain pipe is to
drain water out from the tank when it is full. The Self-Evaporating System will not be actioned when the
compressor is not on activated, e.g. when the unit is on heating or fan mode.