iGage
iG8 User Manual
33
Configuring an iG8 UHF Rover
For information on setting up a Network Rover please turn to “
Configuring an iG8 Network Rover
1.
Setup the Rover:
a.
Attach the receiver to the range pole.
b.
Attach the UHF antenna to the receiver
head.
c.
Put one or two charged batteries into the
head.
d.
Turn on the Rover receiver.
e.
Attach the Data Collector to the range
pole.
2.
If you have not already started a new job or opened
an existing job, refer to the section ‘
Starting a New
SurvCE Job
’ on Page 20 to start and configure a new
SurvCE job.
3.
From the main SurvCE menu click on the Equip tab:
Then click on ‘3 GPS Rover’
4.
Choose the correct Manufacturer ‘iGage’ and Model
‘iG8’:
5.
Select the Comms tab:
Choose ‘Type’ = ‘Bluetooth’, ‘BT Type’ = ‘Windows
Mobile’, then click on the Settings button
(hammer/wrench) button to the right of ‘BT Type’.
6.
The Bluetooth Devices menu is shown:
If your receiver is not listed, click on ‘Find Device’
