SmartPLC DataLine with EtherNet/IP device interface
44
>
5.3.7
Quick setup: Set the Configuration interface 1
41781
The device provides the following options for configuration of the Ethernet Configuration interface 1:
Manual =
The operator sets the interface parameters (IP address, network mask,
gateway address) manually.
Automatic =
The interface parameters are set automatically. The operator can choose
between these protocols:
– Dynamic Host Configuration Protocol (DHCP)
– Zero Configuration Networking (Zeroconf)
The device must be connected to a DHCP server to automatically receive the interface
parameters via DHCP.
► Connect the configuration interface (X3) to a DHCP server.
To configure the IP parameters of the configuration interface:
1 Select the menu page
►
►
Select [Config. interface X3] tab.
2 Show the active settings
>
The parameters below show the active settings:
Parameter
Description
Possible values
[Optain IP address
autom.]
Active method for the
configuration of the interface
parameters
Manual assignment of the interface parameters through the
operator
Automatic assignment of the interface parameters
[IP status]
Configuration protocol used
[Static]
The operator sets the IP parameters manually.
[DHCP]
The IP parameters are set by a DHCP server.
[Zeroconfig]
The IP parameters are set automatically with the
Zeroconf protocol.
[IP address]
IP address of the interface
e.g.
192.168.0.100
[Subnet mask]
Network mask of the network
segment
e.g.
255.255.255.0
[Gateway address]
IP address of the network
gateway
e.g.
192.168.0.1
►
Take one of the following actions:
– Configure the IP parameters manually: continue with → step 3
– Configure the IP parameters automatically: continue with → step 4
3 Configure the IP parameters manually
►
Uncheck [Optain IP address autom].
►
Set the following parameters as required:
– [IP address]
– [Subnet mask]
– [Gateway address]
►
Press [Accept] to save the changes.
