IFM SD26 Series, Operating Instructions Manual

Page: 41 / 50

41
UK
10.6 User settings (optional)
10.6.1 Standard display
► Select [diS�L] and set process value display:
-L1 = current process value for volumetric flow
-L2�Temp = current process value for flow and temperature
-L2�Pres = current process value for volumetric flow and pressure
-L2�Totl = current process value for volumetric flow and totaliser
-L3�TP = current process value for volumetric flow and
temperature and pressure
-L4 = current process value for volumetric flow and
temperature and pressure and current totaliser value
► Select [diS�U] and set refresh rate of the display:
-d1 = high
-d2 = medium
-d3 = low
► Select [diS�R] and set the orientation of the display:
0°, 90°, 180°, 270°
► Select [diS�B] and set the brightness of the display:
25 %, 50 %, 75 %, 100 %
or OFF (= energy-saving mode� The display is switched off in the
operating mode� Error messages are displayed even if the display is
deactivated� Display activation by pressing any key�)
Menu DIS:
[diS�L]
[diS�U]
[diS�R]
[diS�B]
10.6.2 Standard unit of measurement for volumetric flow
► Select [uni�F] and set unit of measurement for standard display (→ 8.1) :
l/min, m
3
/h, m/s, ft
3
/m ft
3
/h, ft/s�
The consumed quantity (meter reading) is automatically displayed
in the unit of measurement providing the highest accuracy�
Menu CFG:
[uni�F]
10.6.3 Standard unit of measurement for temperature
► Select [uni�T] and set unit of measurement for standard display (→ 8.1) :
°C or °F
Menu CFG:
[uni�T]
10.6.4 Standard unit of measurement for pressure
► Select [uni�P] and set unit of measurement for standard display (→ 8.1) :
kPa, bar, psi�
Menu CFG:
[uni�P]