SB1xxx SB2xxx SB3xxx SB4xxx SB5xxx SB6xxx SB7xxx SB8xxx SB9xxx SB03xx
Mechatronic flow
sensor
8
5.3 Mounting accessories
u
If necessary, fasten the unit on the mounting plate (not supplied) from underneath.
27
1
Fig. 2: Installation with mounting plate
1:
threaded hole M8 (depth 6 mm) on the bottom side of the unit
Information about available accessories at www.ifm.com
5.4 Installation in case of medium containing dirt
u
Use a 200-micron filter in front of the inlet (IN).
u
Install sensor horizontally.
u
Adhere to the inclination angle to the horizontal axis:
± 5°
± 90°
Fig. 3: Alignment in case of medium containing dirt
In clean medium, installation in vertical pipes is also possible.
Information about available filters at
