29
10 Set-up
After power on and expiry of the power-on delay time, the unit is in the normal
operating mode. It carries out its measurement and evaluation functions and
generates output signals according to the set parameters.
During the power-on delay time the outputs are switched as programmed:
• ON with normally open function (Hno / Fno)
• OFF with normally closed function (Hnc / Fnc)
• OFF for frequency output (FRQ)
• 20 mA for current output (I)
11 Parameter setting
CAUTION
If the medium temperature is above 50 °C (122 °F), parts of the
housing can increase in temperature to over 65 °C (149 °F).
w
Risk of burns
u
Do not touch the device with your hands.
u
Use another object (e.g. a ballpoint pen) to carry out settings on
the unit.
Parameters can be set before installation and set-up of the unit or during
operation.
If you change parameters during operation, this will influence the function
of the plant.
u
Ensure that there will be no malfunctions in your plant.
During parameter setting the unit remains in the operating mode. It continues to
monitor with the existing parameter until the parameter setting has been
completed.
The parameters can also be set via the IO-Link interface.
GB
