IFM OPD101, Operating Instructions Manual

Page: 30 / 40

OPD101
30
u Select the required profile using [▲ / ▼].
u
Confirm your selection by pressing [●].
w
The display changes to the RUN mode.
[Add new profile]:
u
Confirm the parameter with [●].
w The sensor changes to the “Guided Teach”.
w The message [Place object and press confirm] appears in the display. Set-up ( Ò / 17).
[Delete profile]:
u
Confirm the parameter with [●].
u
Select the profile to be deleted using [▲ / ▼].
u
Confirm your selection by pressing [●].
If the activated profile is to be deleted, a confirmation screen appears.
If the activated profile has been deleted, no matching value can be determined. In RUN mode, a
corresponding information appears on the display.
The menu item [Profile manager] is enabled when [Profile source select] = local. Submenu
[Configuration] (
Ò /
31).
The menu item [Profile manager] is disabled when [Profile source select] = PDOut. Submenu
[Configuration] (
Ò /
31).
In the latter case, the settings can only be made via IO-Link or the ifm parameter setting
software.
11.1.5 [Extended functions]
Change to the menu level of extended functions.
Extended functions ( Ò / 24)
11.1.6 [Back]
u
Confirm the parameter with [ENTER].
w
The display changes to the RUN mode.
11.2 Parameter level extended functions
In the parameter level extended functions the following parameters can be selected:
11.2.1 [Factory setting]
Reset all parameters to factory setting
u Confirm the parameter with [●] and select one of the options [NO] / [YES] using [▲ / ▼]:
u Select [YES] and confirm with [●]:
w
The sensor resets all parameters to factory setting and changes to the “Guided Teach”.
11.2.2 [Device information]
Sensor information
u Confirm the parameter with [●] and navigate through the information lines using [▲ / ▼].