17
UK
7.1 Teach device
Use the teach button to teach the device new codes�
Below the teach process for new codes using the teach button
⑦
is described:
►
Avoid back light, scattered light and changing light conditions�
>
See notes on how to install the device (→ 5).
►
Press the teach button for 3 seconds�
> The green teach LED
①
is permanently on�
> 2 red laser points can be seen on the surface�
►
Place a code in the zone marked by the red laser points�
> The code must be of high quality and of high contrast�
> The device focusses the code better if the background looks uninteresting�
> Several codes in the marked zone make the teaching process of a certain code
more difficult�
►
Press the teach button for 1 second�
> The yellow teach LED
⑥
flashes while the code is being taught�
> The code is taught if the green teach LED briefly flashes and is then on for
>
The code is not taught if the yellow teach LED briefly flashes (→ 7).
7.1.1 Configure teaching
The teaching of codes is configured with the ifm Vision Assistant software� The
recognition of codes can, for example, be restricted�
The ifm Vision Assistant software and the software manual are available on
the internet: www�ifm�com
7.1.2 Teach app
The teach app is used for the following settings:
• trigger source
• process interface
• IP address
• reset of the device and restoration of the factory settings�
The teach app stores the settings in a data matrix code� The teach button is used
to read the code from the device� Then the new settings are active�