IO-Link Master with PROFINET Interface StandardLine 8 Ports IP 65 / IP 66 / IP 67
22
>
8.1
Read device and diagnostic information
34216
In order to read the diagnostic information about the current device status via the web interface:
►
Connect laptop/PC and AL1102 via the Ethernet internet.
►
Start web browser.
►
Enter the IP address of the AL1102 into the address field of the browser and press [ENTER] to confirm.
>
Web browser shows the web interface of the device.
>
The page shows the following data:
Table with connected IO-Link devices
Name
Description
[Port]
Number of the IO-Link interface
[Mode]
Operating mode of the IO-Link interface
[Comm. Mode]
Baud rate of the IO-Link interface
[MasterCycleTime]
Cycle time
[Vendor ID]
ID of the manufacturer of the IO-Link device
[Device ID]
ID of the IO-Link device
[Name]
Article number of the IO-Link device
For ifm articles: This article number is stored along with a link to the produkt page on
the ifm website.
[Serial]
Serial number of the IO-Link device
[LR Mode / Interval]
Cycle time for the communication with the SmartObserver
Diagnostic information of the device
Name
Description
[SW-Version]
[Current]
Current (in mA)
[Voltage]
Voltage (in mV)
[Short Circuit]
Number of detected short circuits
[Overload]
Number of detected overloads
[Undervoltage]
Number of detected under voltages
[Temperature]
Device temperature (in °C)
Version information of the installed firmware components
Name
Description
[Firmware]
Firmware version
[Container]
Version of the firmware container
[Bootloader Version]
Version of the boot loader
[Fieldbus Firmware]
Version of the PROFINET firmware
