EIO104
Converter IO-Link sensor ‒ 4…20 mA
10
u
Use IO-Link cable with IP class.
u
Connect the connector with the device. The arrow indicates the position of the coding.
u
Tighten the coupling nut.
•
Minimum tightening torque: 0.6 Nm (tightening by hand).
•
Maximum tightening torque: 1.5 Nm (using a torque wrench).
5.2 Removing the connector
u
Loosen the coupling nut and simultaneously press the connector against the device.
5.3 UL application area
For use in the USA and Canada:
u
For connecting the device and the IO-Link sensor, use UL-certified cables of category CYJV 2/7/8
having suitable ratings.
5.4 Cable length
•
Maximum cable length on the input side (IO-Link): 20 m.
•
Maximum cable length on the output side (analogue signal): no recommendation, depending on
receiver.
u
Provide all input and output side cables with a strain relief approx. 200 mm behind the connectors.
