ifm
Basic Device Manual AS-i ControllerE M4 Target V15
2015-10-30
Set-up
Set the baud rate of the serial interface
123
NOTE
► Set the same value on the PC!
11.1.1
Install target for the controllere
► Install the current target for the AS-i controllere, if not yet done:
1.
► Click on [Start] > [Programs] > [CoDeSys] > [InstallTarget] on the PC
2.
► Click on [Open] to open the installation
file "Target Information File" (*.TNF)
3.
► Select the source directory for the new
target (from the installation CD) and
confirm with [Open]
4.
► Mark the target for the controllere (→
figure)
► Start installation with [Install]
>
Message "The installation directory does
not exist. Create?"
OR:
Message "The target ... already exists.
Overwrite it?"
► Confirm with [Yes]
>
Target is being installed
► Finish with [Close]
>
That's it! The new target is installed.
