67
ifm
Programming Manual ecomatController/60-1 (CR711S) Operating System V2.5.0.n
2017-12-19
System configuration
Configure inputs and outputs
>
7.2
Configure inputs and outputs
23099
The inputs and outputs can be configured applying two methods:
>
7.2.1
via system configuration
23149
This method is useful if the configuration is not supposed to be changed again during the runtime of
the application.
Note: Only the I/Os allocated to the PLC can be configured!
Procedure using the example of the operating mode of an input / output:
► In the CODESYS device tree: Extend required PLC > Element [Local_IO]
► Double-click on [Inputs] / [Outputs]
► Click on [Parameters] tab
>
The parameter setting view of the inputs / outputs appears
► Select input / output from the list
► Double-click in the column [Value] of the parameter [Mode]
► Click on arrow symbol
>
List of possible modes appears
► Click on the required mode
>
The mode for the input / output is set
► If needed, set further parameters as described, e.g. filters, periods, frequency, etc.
>
7.2.2
via function block
23150
This method is useful if the configuration is supposed to be changed during the runtime of the
application.
The operating type of the inputs and outputs is set via the block input eMode of the following FBs.
Examples:
FB
Input
(
) > Input eMode
FB
Output
(
) > Input eMode
FB
OutputGroup
> Input eMode
