16
9 Set-up
After power on and expiry of the power-on delay time of approx� 10 s the unit is in
the Run mode (= normal operating mode)� It carries out its measurement and eval-
uation functions and generates output signals according to the set parameters�
•
During the power-on delay time the outputs are switched as programmed:
-ON with normally open function (Hno / Fno)
-OFF with normally closed function (Hnc / Fnc)�
10 Parameter setting
Parameters can be set before installation and set-up of the unit or during opera-
tion�
If you change parameters during operation, this will influence the function
of the plant�
►
Ensure that there will be no malfunctions in your plant�
During parameter setting the unit remains in the operating mode (Run mode)� It
continues to monitor with the existing parameter until the parameter setting has
been completed�
CAUTION
For medium temperatures above 50 °C (122 °F) some parts of the housing can
heat up to over 65 °C (149 °F)�
►
Do not press the pushbuttons manually; instead use another object (e�g�
ballpoint pen)�
