24
9.3 Explanation of the menu
SP1/rP1
Upper / lower limit value for the level at which OUT1 switches�
FH1/FL1
Upper / lower limit for the acceptable range (monitored by OUT1)�
SP2/rP2
Upper / lower limit value for the level at which OUT2 switches�
FH2/FL2
Upper / lower limit for the acceptable range (monitored by OUT2)�
SP3/rP3
Upper / lower limit value for the level at which OUT3 switches�
FH3/FL3
Upper / lower limit for the acceptable range (monitored by OUT3)�
SP4/rP4
Upper / lower limit value for the level at which OUT4 switches�
FH4/FL4
Upper / lower limit for the acceptable range (monitored by OUT4)�
OUx
Output function for OUTx:
• Switching signal for the level limit values: hysteresis function [H ��] or
window function [F ��], either normally open [� no] or normally closed [� nc]�
OFS
Offset value for level measurement
EF
Extended functions / opening of menu level 2�
rES Restore factory settings�
dr1 Switch-off delay for OUT1� The menu item is only active if OU1 = Hno or
Hnc�
dr2 Switch-off delay for OUT2� The menu item is only active if OU2 = Hno or
Hnc�
dr3 Switch-off delay for OUT3� The menu item is only active if OU3 = Hno or
Hnc�
dr4 Switch-off delay for OUT4� The menu item is only active if OU4 = Hno or
Hnc�
FOUx Response of OUTx in case of a fault�
dFo Delay time for switching response OUTx in case of a fault�
Uni Unit of measurement (cm or inch)�
SELd Type of indication�
LEnG Length of the rod�
bin Changing between switching mode and binary mode�
