IFM Electronic AL1102, Operating Instructions Manual, Page: 32 / 79

32
ifm Operating Instructions IO-Link Master with Profinet interface StandardLine 8 Ports IP 65 / IP 67 (AL1102) 2017-05-31
Configuration
>
8.2 LR DEVICE: Configure the device
Set-up .....................................................................................................................................................33
Configure communication profile ............................................................................................................34
Configure the Ethernet interface ............................................................................................................35
Configure the interface to the SmartObserver........................................................................................36
Set the operating mode of the IO-Link ports ..........................................................................................37
Set device validation and data storage ..................................................................................................38
Reset IO-Link master to factory settings ................................................................................................40
22402
The IO-Link master and the IO-Link devices connected to the AL1102 can be configured with the ifm
software LR DEVICE.
Further information about operation and functions of the LR DEVICE parameter setting
software:
► Use the help function of the parameter setting software LR DEVICE!
In order to configure the AL1102 with the LR DEVICE.
►
Put AL1102 into operation (→ Set-up (→ p. 33 )).
►
Under [ONLINE]: Click on the AL1102.
> LR DEVICE shows the following sections:
Section Functions
[All] all available functions
[Network]
→ Configure the Ethernet interface
(
→ p.
35 )
[LineRecorder]
→ Configure communication profile
(
→ p.
34 )
→ Configure the interface to the SmartObserver
(
→ p.
36 )
[Port x]*
→ Set the operating mode of the IO-Link ports
(
→ p.
37 )
→
Set device validation and data storage
(
→ p.
38 )
[Setup]
→
LR DEVICE: Read device information
(
→ p.
57 )
→
Reset IO-Link master to factory settings
(
→ p.
40 )
→ Reboot the device
(
→ p.
58 )
* ... x = 1...8