AUTOMATIC DETERGENT DISPENSER TRAY
Designed for automatic dispensing of
detergent & additives as required, which
avoids manual filling at each stage.
The Detergent Dispenser Tray should be filled (
with detergent and additives) before the start
of a programme The tray has three chambers.
1. Pre-wash chamber: (Marked-I),to be filled with
detergent in case a pre-wash programme ( A
or G ) has been chosen or heavily soiled
clothes are being washed.
2. Main wash chamber: (Marked-II), requires
detergent for every wash programme. (B/C/D
or H/K or N)
3. Fabric conditioner additives chamber:
(Marked ), to be used for additives only. It
should be filled as per instructions under
‘OPERATION’.
The detergent tray must be pulled out, filled as
required
and shut before the machine is
switched on.
SELECTOR BUTTONS
Water Plus Button
“Water Plus” button provides an option for
using
15-25% additional water for
q
Heavy laundry of medium and heavily
soiled clothes
q
Light & medium soiled clothes which are
not part of daily wash or washed after
relatively longer duration of use as in the
case of Curtains, Bedsheets, Jeans etc.
Spin Cancel Button ( No spin )
q
When this button is pressed, there will be
no spin and the programme continues
without spinning.
Spin Speed Selector Button
Automatically regulates spin speed.
II
I
13
DRUM
Rust Stains
Never leave metal items e.g. paper clips, safety
pins etc. in the drum as it creates superficial rust
marks in drum. If there are any rust stains remove
with a non-chlorine agent. Special non-metal
sponges (never use steel wool ) may also be used.
SIEVES
Cleaning of Water Connection Sieves, filter
1.
Turn off Taps. Disconnect Power supply to the
machine. Unscrew inlet hose from machine as
well as from the tap and drain out water from the
hose.
2.
Pull the sieve out the magnetic valve with a pair of
flat nosed pliers and clean under running water
with a brush.
3. Fit Sieve back to the valve.
4.
Remove the filter mesh from the tap end of the
inlet hose and clean under running water with a
brush.
5.
Fit the filter mesh back to inlet hose.
6.
Screw inlet hose back to the machine and the tap.
Ensure that both the sieves and Filter are in place.
7. Turn on the tap.
Cleaning of Porthole Door Area:
q
After every wash clean vapour off porthole
door.
q
Lift the fold in the rubber gasket under porthole
periodically to remove lint and dirt preferably
after every wash.
FROST PROTECTION
If the machine is being operated in very cold temperature, all the
water should be drained out after use.
q
Remove Fluff Filter
q
Locate the drain hose and drain the water.
q
Disconnect inlet hose from the tap and drain.
DRAINING DURING EMERGENCIES
In case of a long power failure during a programme run, the
water can be drained from the drum through the drain hose
q
Allow the water in the machine to cool down sufficiently.
q
Locate the drain hose and pull out the drain hose to drain water
in a large shallow container.
q
Before restarting machine, ensure that drain plug is fixed on
drain hose properly and fluff filter water line is filled with water by
running the machine without any clothes or detergents.
q
Spillage of water can rust the base plate. Draining through drain
hose prevents rusting.
28