www.ies-synergy.com
User Manual
DUM019665-EN
15
4) EV communication
This step is necessary to adapt the charger parameters to the EV.
Observe the display; charging will begin once communication has been established between the charger and
the EV.
BIP
Note:
Applicable in COMBO, CHAdeMO and AC
Note:
Applicable in COMBO and CHAdeMO
EV charge
Only one DC connector and one AC connector can be used under simultaneous charge.
The charging station displays the:
• time since the start of charging
• charged energy
• percentage of charge (not in AC)
Note:
Applicable in COMBO and CHAdeMO
Note:
Applicable in AC
The charger will automatically stop once charging is completed. Fast charging will occur up to 80% of the
vehicle battery state of charge. The charger will adjust its output according to the demands of the vehicle,
ambient temperature and other factors.
After completing the charge of the EV, the charging station performs multiple control steps before disconnect-
ing the vehicle.
