3.3
L
OADING
R
OLL
M
EDIA
- S
ECOND
G
ENERATION
M
EDIA
H
OLDER
3.3.1. Procedure
IMPORTANT : When installing the media roll, make sure that the
heat-sensitive side of the media will be facing up when
inserted into the printer.
a) Slide the roll media holder adjustment pin (3) outwards.
b) Place the media roll (2) on the plastic spindle (4) and set it
against the holder (1).
c) Slide the pin (3) back and set it against the roll.
1 - Roll Media Holder
2 - Media roll
3 - Adjustment pin
4 - Spindle
Figure 3.4
Installing Roll Media
PRINTER IER 506B
User Guide
Page 18
N0B402A Rev. 1
May 25, 2007
Ce document est la propiété d'IER et ne doit pas être reproduit ou communiqué sans autorisation écrite.
This document is the property of IER and may not be reproduced or communicated without prior written authorization