3.2
L
OADING
R
OLL
M
EDIA
- F
IRST
G
ENERATION
M
EDIA
H
OLDER
3.2.1. Procedure
IMPORTANT : When installing the media roll, make sure that the
heat-sensitive side of the media will be facing up when
inserted into the printer.
a) Remove the removable flange (4).
b) Place the media roll (2) on the plastic hubs (3) and set it against
the fixed flange (1).
c) Install the removable flange (4) on the spindle of the media
holder and set it against the media roll (2).
1 - Fixed flange
2 - Media roll
3 - Plastic hubs
4 - Removable flange
5 - Media insertion slot
Figure 3.2
Installing Roll Media
PRINTER IER 506B
User Guide
Page 16
N0B402A Rev. 1
May 25, 2007
Ce document est la propiété d'IER et ne doit pas être reproduit ou communiqué sans autorisation écrite.
This document is the property of IER and may not be reproduced or communicated without prior written authorization