GB
9 - PART REPLACEMENT
KID 70
9 - Pag. 2 / 4
9.1
PRELIMINARY NOTE ON PARTS REPLACEMENT
Before carrying out any replacement, start all safety devices provided and check if it is
necessary to inform the staff operating around and people close to the area. In particular, it is
recommended to adequately signal the adjacent areas and to prevent anyone from approaching
all the devices that, if started, could cause unexpected damages and harm to people.
If it proves necessary to replace worn components, use only original spare parts.
We disclaim any responsibility for damages to components and injury to people derived from
the use of non-original spare parts and from any repair carried out without the manufacturer's
authorisation.
For spare parts ordering, follow the indications reported on the spare parts catalogue.
9.2
REPLACEMENT OF THE FIXED TIP
For replacement proceed as follows:
- Lift the upper cover.
- Remove the bar pusher, see paragraph 6.8.
- Pull off the pin (A) to remove the fixed tip.
- Install the new fixed tip and fasten it by means
of a new pin.
- Install the bar pusher again.
- Close the upper cover.