IEM Tel-O-Graph GSM, Operating Manual

Page: 82 / 304

Memory
30
8.2 Deleting readings from the blood pressure
monitor
To clear the memory on your blood pressure monitor,
proceed as follows:
Fig. 11: Delete measurements
1) Press and hold the button on the blood
pressure monitor for about 3 seconds.

The display shows [IP] (see Fig. 11A).
Note
The display automatically shows each menu
entry for 3 seconds. The display order is:
➔
Mobile network transmission (IP)
➔
Infra-red transmission (IR)
➔
Delete measurements (c lr)
Note
The menu options "Mobile network transmission
(IP)" and
“Infra-red Transmission (IR)”
are
provided for servicing purposes and you do not
need to use it.
2) Wait until [c lr] flashes on the display (Fig. 11 C).
3) Press the
button.

You will hear an acoustic signal and the display
will be shown [c lr] permanently.
4) Press and hold the button for more than
3 seconds.

The acoustic signal sounds 3 times and the
display shows [M00] (see Fig. 11/C).
The measurements are deleted. The device returns to
standby mode and displays the
start screen
(see Fig. 6).