IEI Technology WSB-9154, User Manual

Page: 94 / 227

WSB-9154 CPU Card
Page 76
Step 2: Align the DIMM with the socket . The DIMM must be oriented in such a way
that the notch in the middle of the DIMM must be aligned with the plastic bridge
in the socket. See Figure 5-7 .
Step 3: Insert the DIMM . Once properly aligned, the DIMM can be inserted into the
socket. As the DIMM is inserted, the white handles on the side of the socket will
close automatically and secure the DIMM to the socket. See Figure 5-7 .
Step 4: Removing a DIMM . To remove a DIMM, push both handles outward. The
memory module is ejected by a mechanism in the socket. Step 0:
5.4 Jumper Settings
NOTE:
A jumper is a metal bridge used to close an
electrical circuit. It consists of two or three metal
pins and a small metal clip (often protected by a
plastic cover) that slides over the pins to connect
them. To CLOSE/SHORT a jumper means
connecting the pins of the jumper with the plastic
clip and to OPEN a jumper means removing the
plastic clip from a jumper.
Figure 5-8: Jumpers
Before the WSB-9154 is installed in the system, the jumpers must be set in accordance
with the desired configuration. The jumpers on the WSB-9154 are listed in Table 5-1 .
Description Label Type
Clear CMOS J_CMOS1 3-pin header
Table 5-1: Jumpers