IEI Technology WAFER-BT, User Manual

Page: 62 / 114

WAFER-BT
P a g e 50
Figure 4-6: Flash Descriptor Security Override Jumper Location
4.5 In te rn a l P e rip h e ra l De vic e Co n n e c tio n s
This section outlines the installation of peripheral devices to the on-board connectors
4.5.1 Au d io Kit In s ta lla tio n
The Audio Kit that came with the WAFER-BT connects to the audio connector on the
WAFER-BT. The audio kit consists of three audio jacks. Mic-in connects to a microphone.
Line-in provides a stereo line-level input to connect to the output of an audio device.
Line-out, a stereo line-level output, connects to two amplified speakers. To install the
audio kit, please refer to the steps below:
S te p 1: Locate the audio connector . The location of the 10-pin audio connector is
shown in Chapter 3 .
S te p 2:
Align pin 1 . Align pin 1 on the on-board connector with pin 1 on the audio kit
connector. Pin 1 on the audio kit connector is indicated with a white dot. See
Figure 4-7.