IEI Technology uIBX-230-BT Series, User Manual

Page: 20 / 96

u IBX-230-BT Em b e d d e d S ys te m
P a g e 11
3.1 In s ta lla tio n P re c a u tio n s
During installation, be aware of the precautions below:

Read the user manual : The user manual provides a complete description of
the uIBX-230-BT, installation instructions and configuration options.

DANGER! Disconnect Power : Power to the uIBX-230-BT must be
disconnected during the installation process, or before any attempt is made to
access the rear panel. Electric shock and personal injury might occur if the
rear panel of the uIBX-230-BT is opened while the power cord is still
connected to an electrical outlet.

Qualified Personnel : The uIBX-230-BT must be installed and operated only
by trained and qualified personnel. Maintenance, upgrades, or repairs may
only be carried out by qualified personnel who are familiar with the associated
dangers.

Grounding : The uIBX-230-BT should be properly grounded. The voltage
feeds must not be overloaded. Adjust the cabling and provide external
overcharge protection per the electrical values indicated on the label attached
to the back of the uIBX-230-BT.
3.2 In s ta lla tio n a n d Co n fig u ra tio n S te ps
The following installation steps must be followed.
S te p 1: Unpack the uIBX-230-BT.
S te p 2: Configure the system.
S te p 3:
Connect peripheral devices to the uIBX-230-BT.
S te p 4: Mount the uIBX-230-BT. S te p 0:
3.3 Ha rd Dis k Drive (HDD) In s ta lla tio n
To install the hard drive, please follow the steps below:
S te p 1: Remove three retention screws from the HDD cover ( Figure 3-1 ).