IEI Technology TANK-801, User Manual

Page: 31 / 98

TANK-801 Em b e d d e d S ys te m
P a g e 21
Figure 3-8: System Fan Installation
S te p 4: Connect the system fan cable to the CPU_FAN connector on the motherboard
of TANK-801.
S te p 5: Reconnect the SATA signal and power cables to the TANK-801.
S te p 6:
Reinstall the cover.
3.5 P lu g g a b le DC-In Te rm in a l Blo c k In s ta lla tio n
To install the pluggable DC-in terminal block, please follow the steps below:
S te p 1:
Locate the DC-in terminal block connector. The location of the connector is
shown in Figure 1-2 .
S te p 2:
Align the pluggable DC-in terminal block with the DC-in terminal block connector
on the TANK-801.
S te p 3:
Once aligned, insert the pluggable DC-in terminal block into the DC-in terminal
block connector.
S te p 4: Secure the pluggable DC-in terminal block to the external interface by tightening
the two retention screws on either side of the terminal block ( Figure 3-9 ).