IEI Technology TANGO-7010 Series, User Manual, Page: 33 / 125

Page 22
TANGO-7010 Embedded System
3.5.2 LAN Connection
The LAN connectors allow connection to an external network.
Step 1:
Locate the RJ-45 connectors. The locations of the RJ-45 connectors are shown
in Chapter 1 .
Step 2:
Align the connectors. Align the RJ-45 connector on the LAN cable with one of
the RJ-45 connectors on the TANGO-7010 Series. (See Figure 3-12).
Figure 3-12: LAN Connection
Step 3:
Insert the LAN cable RJ-45 connector. Once aligned, gently insert the LAN cable
RJ-45 connector into the on-board RJ-45 connector.
The RJ-45 Ethernet connector has two status LEDs, one green and one yellow. The green
LED indicates activity on the port and the yellow LED indicates the port is linked. See
Table 3-1
Activity/Link LED Speed LED
STATUS DESCRIPTION STATUS DESCRIPTION
Off No link Off 100 Mbps connection
Yellow Linked Orange 1 Gbp connection
Blinking TX/RX activity Green 2.5 Gbps connection
Table 3-1: RJ-45 Ethernet Connector LEDs