IEI Technology PPC-3708, User Manual

Page: 70 / 161

PPC-3708/PPC-3710/PPC-3712 Panel PC
Figure 3-23: Suggested Panel Cut Out Size for PPC-3708
Figure 3-24: Suggested Panel Cut Out Size for PPC-3710
Step 3:
Slide the PPC-3708/PPC-3710 flat panel computer through the previously cut
hole. The chassis at the rear of the PPC-3708/PPC-3710 flat panel should slide
easily through the hole. Only stop sliding the panel through the hole when the
back of the front aluminum frame is flush against the panel.
Step 4:
Insert the panel mounting clamps into the pre-formed holes along the edges of
the chassis, behind the aluminum frame. There are a total of 8 panel mounting
clamps for PPC-3708 and 10 clamps for PPC-3710.
Step 5:
Tighten the screws that pass through the panel mounting clamps until the plastic
Page 70