IEI Technology PPC-3708, User Manual

Page: 49 / 161

PPC-3708/PPC-3710/PPC-3712 Panel PC
Step 1:
Unpack the flat panel PC
Step 2:
Set the jumper settings
Step 3:
Install CPU and CPU cooler (/8522 and /8522/T-R models only)
Step 4:
Install HDD and CD drive
Step 5:
Mount the flat panel PC
Step 6:
Connect peripheral devices to the bottom panel of the flat panel PC
Step 7:
Configure the system
Step 0:
3.4 Unpacking
To unpack the flat panel PC, follow the steps below:
WARNING!
The front side LCD screen has a protective plastic cover stuck to the
screen. Only remove the plastic cover after the flat panel PC has been
properly installed. This ensures the screen is protected during the
installation process.
Step 1:
Use box cutters, a knife or a sharp pair of scissors that seals the top side of the
external (second) box.
Step 2:
Open the external (second) box.
Step 3:
Use box cutters, a knife or a sharp pair of scissors that seals the top side of the
internal (first) box.
Step 4:
Lift the monitor out of the boxes.
Step 5:
Remove both polystyrene ends, one from each side.
Step 6:
Pull the plastic cover off the flat panel PC.
Step 7:
Make sure all the components listed in the packing list are present.
Step 0:
Page 49