IEI Technology POC-17C-ULT3, User Manual, Page: 52 / 163

POC-17C-ULT3 Medical Panel PC
Page 37
3.10.2 ATX Power Mode
With the ATX mode selected, the POC-17C-ULT3 panel PC goes in a standby mode when
it is turned off. The panel PC can be easily turned on via network or a power switch in
standby mode.
3.11 Cable Cover Installation
An optional cable cover can be installed on the POC-17C-ULT3 for the user to easily
manage cables. To install the cable cover, please follow the instruction below.
Step 1:
Align the slot on the rear of the cable cover with the tab on the bottom panel of
the POC-17C-ULT3 (
Figure 3-25
). Then, attach the slot to the tab.
Figure 3-25: Aligning the Tab on the Bottom Panel
Step 2:
Push six tabs on the cable cover (as shown in
Figure 3-26)
into the slots on the
rear panel of the POC-17C-ULT3. More strength is required to push the tabs into
the slots.