IEI Technology PCIE-Q870-i2, User Manual

Page: 83 / 182

PCIE-Q870-i2 PICMG 1.3 CPU Card
Page 67
Figure 4-21: VGA Connector
Step 4: Secure the connector . Secure the DB-15 VGA connector from the VGA
monitor to the external interface by tightening the two retention screws on either
side of the connector. Step 0:
4.7 Intel
®
AMT Setup Procedure
The PCIE-Q870-i2 is featured with the Intel® Active Management Technology (AMT). To
enable the Intel® AMT function, follow the steps below.
Step 1: Make sure the DIMM socket is installed with one DDR3 memory.
Step 2: Connect an Ethernet cable to the RJ-45 connector labeled LAN1 .
Step 3: The AMI BIOS options regarding the Intel® ME or Intel® AMT must be enabled,
Step 4: Properly install the Intel® Management Engine Components drivers from the
iAMT Driver & Utility directory in the driver CD. See Section 6.8 .
Step 5: Configure the Intel® Management Engine BIOS extension (MEBx). To get into
the Intel® MEBx settings, press <Ctrl+P> after a single beep during boot-up