IEI Technology PCIE-9152, User Manual

Page: 78 / 194

PCIE-9152 PCIMG 1.3 CPU Card
Page 62
5.4 Jumper Settings
NOTE:
A jumper is a metal bridge used to close
an electrical circuit. It consists of two or
three metal pins and a small metal clip
(often protected by a plastic cover) that
slides over the pins to connect them. To
CLOSE/SHORT a jumper means
connecting the pins of the jumper with
the plastic clip and to OPEN a jumper means removing the plastic clip
from a jumper.
Before the PCIE-9152 is installed in the system, the jumpers must be set in accordance
with the desired configuration. The jumpers on the PCIE-9152 are listed in Table 5-1 .
Description Label Type
CF card setup JP5 2-pin header
Clear CMOS JP1 3-pin header
FSB Selection JP3 3-pin header
LVDS voltage selection JP2 3-pin header
Table 5-1: Jumpers
5.4.1 CF Card Setup
Jumper Label: JP5
Jumper Type: 2-pin header
Jumper Settings: See Table 5-2
Jumper Location: See Figure 5-8