IEI Technology PCIE-690AM2, User Manual, Page: 108 / 234

PCIE-690AM2 PICMG 1.3 CPU Card
Page 86
Figure 5-8: FDD Cable Connection
Step 3: Connect the cable to an FDD device . Connect the connector at the other end
of the cable to an FDD device. Make sure that pin 1 on the cable corresponds to
pin 1 on the connector. Step 0:
5.7.5 Dual RS-232 Cable Connection
The dual RS-232 cable consists of two connectors attached to two independent cables.
Each cable is then attached to a D-sub 9 male connector that is mounted onto a bracket.
To install the dual RS-232 cable, please follow the steps below.
Step 1: Locate the connectors . The locations of the RS-232 connectors are shown in
Chapter 3 .
Step 2: Insert the cable connectors . Insert one connector into each serial port box
headers. See Figure 5-9 . A key on the front of the cable connectors ensures the
connector can only be installed in one direction.