IEI Technology NANO-QM770-R10, User Manual

Page: 70 / 145

NANO-QM770 EPIC SBC
Page 56
Figure 4-14: Single RS-232 Cable Installation
Step 3: Secure the bracket . The single RS-232 connector has two retention screws
that must be secured to a chassis or bracket.
Step 4: Connect the serial device . Once the single RS-232 connector is connected to
a chassis or bracket, a serial communications device can be connected to the
system. Step 0:
4.8 Intel
®
AMT Setup Procedure
The NANO-QM770 is featured with the Intel® Active Management Technology (AMT). To
enable the Intel® AMT function, follow the steps below.
Step 1: Make sure the DIMM1 socket is installed with one DDR3 SO-DIMM.
Step 2: Connect an Ethernet cable to the RJ-45 connector labeled LAN1 .
Step 3: The AMI BIOS options regarding the Intel® ME or Intel® AMT must be enabled,
Step 4: Properly install the Intel® Management Engine Components drivers from the
iAMT Driver & Utility directory in the driver CD. See Section 6.9 .
Step 5: Configure the Intel® Management Engine BIOS extension (MEBx). To get into
the Intel® MEBx settings, press <Ctrl+P> after a single beep during boot-up