IEI Technology Nano-PV-D4251, User Manual

Page: 57 / 153

NANO-PV-D4251/N4551/D5251 EPIC SBC
Page 44
4.4.1 SO-DIMM Installation
To install an SO-DIMM, please follow the steps below and refer to Figure 4-1 .
Figure 4-1: SO-DIMM Installation
Step 1: Locate the SO-DIMM socket . Place the board on an anti-static mat.
Step 2: Align the SO-DIMM with the socket . Align the notch on the memory with the
notch on the memory socket.
Step 3: Insert the SO-DIMM . Push the memory in at a 20º angle. (See Figure 4-1 )
Step 4: Seat the SO-DIMM . Gently push downwards and the arms clip into place. (See
Figure 4-1 )
4.5 Jumper Settings
NOTE:
A jumper is a metal bridge used to close an
electrical circuit. It consists of two or three metal
pins and a small metal clip (often protected by a
plastic cover) that slides over the pins to connect
them. To CLOSE/SHORT a jumper means
connecting the pins of the jumper with the plastic
clip and to OPEN a jumper means removing the
plastic clip from a jumper.