IEI Technology Nano-PV-D4251, User Manual

Page: 56 / 153

NANO-PV-D4251/N4551/D5251 EPIC SBC
Page 43
o
When installing or configuring the motherboard, place it on an antistatic
pad. This helps to prevent potential ESD damage.
ƒ
Turn all power to the NANO-PV-D4251/N4551/D5251 off:
o
When working with the NANO-PV-D4251/N4551/D5251, make sure that it
is disconnected from all power supplies and that no electricity is being fed
into the system.
Before and during the installation of the NANO-PV-D4251/N4551/D5251 DO NOT:
ƒ
Remove any of the stickers on the PCB board. These stickers are required for
warranty validation.
ƒ
Use the product before verifying all the cables and power connectors are
properly connected.
ƒ
Allow screws to come in contact with the PCB circuit, connector pins, or its
components.
4.3 Unpacking
When the NANO-PV-D4251/N4551/D5251 is unpacked, please check all the unpacking
list items listed in Chapter 3 are indeed present. If any of the unpacking list items are not
available please contact the NANO-PV-D4251/N4551/D5251 vendor reseller/vendor
where the NANO-PV-D4251/N4551/D5251 was purchased or contact an IEI sales
representative.
4.4 SO-DIMM Installation
SO-DIMM is a critical component of the NANO-PV-D4251/N4551/D5251. If it is not
installed the NANO-PV-D4251/N4551/D5251 cannot run.