IEI Technology NANO-GX2, User Manual, Page: 80 / 172

NANO-GX2 EPIC NANO Motherboard
Page 64
Figure 5-1: CF Card Installation
5.3 Jumper Settings
NOTE:
A jumper is a metal bridge that is used to
close an electrical circuit. It consists of
two metal pins and a small metal clip
(often protected by a plastic cover) that
slides over the pins to connect them.
To CLOSE/SHORT a jumper means
connecting the pins of the jumper with
the plastic clip and to OPEN a jumper
means removing the plastic clip from a
jumper.
Before the NANO-GX2 is installed in the system, the jumpers must be set in accordance
with the desired configuration. The jumpers on the NANO-GX2 are listed in Table 5-1 .
Jumper