IEI Technology NANO-GX2, User Manual, Page: 101 / 172

NANO-GX2 EPIC NANO Motherboard
Page 85
IDE Primary Master
IDE Primary Slave
IDE device configurations are changed or set in the IDE Configuration menu ( BIOS Menu
3 ). If an IDE device is detected, and one of the above listed two BIOS configuration
options is selected, the IDE configuration options shown in Section 6.2.1 appear.
Halt On [All, But Keyboard]
Use the Halt On option to specify what errors detected during the power up process stop
the system.
All Errors
Whenever BIOS detects a non-fatal error the
system is stopped and the user prompted.
No Errors
(D
EFAULT
) The system boot is not stopped for any errors
that may be detected.
All, But Keyboard
The system boot does not stop for a keyboard
error; it stops for all other errors.
All, But Diskette
The system boot does not stop for a disk error;
it stops for all other errors.
All, But Disk/Key
The system boot does not stop for a keyboard
or a disk error; it stops for all other errors.
Base Memory:
The Base Memory is NOT user configurable. The POST determines the amount of base
(or conventional) memory installed in the system. The value of the base memory is
typically 512K for systems with 512K memory installed, or 640K for systems with 640K or
more memory installed.
Extended Memory
The Extended Memory is NOT user configurable. The BIOS determines how much
extended memory is present during the POST. This is the amount of memory above 1MB
located in the memory address map of the CPU.